8 - 20
Hanskamp AgroTech B.V. (the Netherlands)
www.hanskamp.nl/en
Pipefeeder
EN
24VAC & 12
-
24VDC
Safety stickers:
The user and installer are responsible for the safe operation and maintenance of the Pipe-
Feeder. Safety stickers are used to ensure safety in and around the PipeFeeder. These
stickers must be placed correctly. Information about which stickers should be attached
where can be found further on in these instructions for installation and use (for example
Fig. 10).
Applying the stickers:
Make sure the surface is dry and clean.
Make sure the surface temperature is at least 5°C.
Find the right position for the sticker.
Remove a small portion of the foil on the
back.
Place the sticker on the surface and press a small portion of the self-adhesive
layer onto the surface.
Carefully remove the foil and press down the rest of the sticker.
Remove any air bubbles with a needle and use the foil to smoothen the sticker.
Maintenance of the stickers:
Keep the safety stickers clean and legible. Clean the safety stickers with soap and
water. Do not use any solvents or abrasives that could damage the safety stickers.
Replace missing or illegible safety stickers.
Safety stickers are available by Hanskamp. Always use the Article numbers in correspond-
ence.
1702 Warning sticker:
Danger risk of getting your hand
stuck under the pipe.
1755 Warning sticker:
The PipeFeeder can start automa-
tically.
