7 - 20
Hanskamp AgroTech B.V. (the Netherlands)
www.hanskamp.nl/en
Pipefeeder
EN
24VAC & 12
-
24VDC
3. Installation instruction
General description:
Hanskamp’s PipeFeeder is an electric feed dosing system developed for feeding concen-
trates in pellet form (Pic. 1) PipeFeeder is designed for the supply of concentrate, either
linked to the feed computer and used for milking stall feeding
.
Please read the whole in-
stallation instructions and keep the safety instructions in mind.
If the PipeFeeder is controlled by an ControlUnit from Hanskamp, see also installation
instructions Art. No. 1841. This can be requested from the manufacturer. If the PipeFeed-
er is not controlled by the ControlUnit, always consult the manual for the relevant control
unit. If the PipeFeeder incorporates a DosPrint from Hanskamp, please consult the instal-
lation instruction no. 1840 for connecting and adjusting the PCB.
See the annex for the order numbers and names of the various parts
.
Transport and storage:
The PipeFeeder will be shipped in a box containing two PipeFeeders. Where a complete
milking stall feeding installation is being shipped the boxes will be transported on a pal-
let. This pallet is completely sealed and the corners are covered with tape to prevent
damage. The PipeFeeder is also stored this way.
Please note! Always use an appropriate vehicle (forklift truck, pallet fork,
pump truck, etc.) to move the pallet.
Please note! Parts may fall off the pallet/box when it is being unpacked.
The box contains:
1. 2x PipeFeeder feeding dosator;
2. 1x bag with 4 pipe clamps
Art.No.:1902;
3. 2x cover for motor;
4. 2x bag with screws for cover and
grommet
Type description;
To be found on the backside of the pipe,
just under the plastic part
Product
description
Article number
CE
marking
Address
1
Serial
Number
