Lubricate the contact surface
Procedure
1. Clean and remove grease from the
contact surfaces (A) and (B).
2. Apply lubricant, only to contact
surface (A). For the lubricant
specification, refer to section
on page 58.
3. Do not apply lubricant to the
surfaces (B). If there is lubricant on
these surfaces, the friction between
the machine shaft and the shaft of
the gear unit will not be correct.
4. Wait until the lubricant is dry.
Attach the gear unit to the machine shaft
Caution: Make sure that there is no opening between the parts (A), (D) and
(E). If there is an opening, water can come in and cause corrosion.
Note: The parts (F), (G) and (H) are not a part of the gear unit. Speak to H.I.T.
if it is necessary that H.I.T. supplies these parts.
Procedure
1. Install the O-ring (A) on the
machine shaft (B).
2. Move the gear unit (C) until the
surfaces (D) and (E) tightly touch
each other. Use the threaded rod
(F), the nut (G) and the installation
disk (H).
Install the shrink disk
Caution:
• Obey the instructions of the supplier of the shrink disk. Refer to the drive
package documenation.
• Do not tighten the bolts crosswise.
• Do not tighten the bolts when the shrink disk is not at the correct location
on the shaft.
B
B
B
A
G
H
D
E
C
A
B
F
Installation
IM_405_002_EN
33
