Page EN-32
Troubleshooting table
Problem
Possible cause
Solution
The LED (2) is illu-
minated although dish-
washer salt has been
added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not running
or it is running only very
slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so
that it is not kinked (see „Connect
the inlet hose“ on page EN-24).
The water tap is not turned on
properly.
Turn the water tap on completely.
The water is not running
off or only very slowly.
The filters are blocked.
Clean the filters (see „Cleaning the
filters“ on page EN-22).
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
Lay out the outlet hose in the proper
manner (see page EN-24).
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced (see
„Service“ o page EN-34).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see „Service“ o page EN-34).
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
The dishwasher cannot
be operated.
The buttons are locked.
Unlock the buttons (see „Button
lock / child lock“ on page EN-21).
The dishwashing results are not satisfactory
Problem
Possible cause
Solution
There are residues or
streaks on the dishes.
The rinse aid is incorrectly
dosed.
Adjust the dispensed dose (see
„Adding rinse aid“ on page EN-11).
There is no dishwasher salt.
Add dishwasher salt (see „Adding
dishwasher salt“ on page EN-12).
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
