Page EN-29
Installation, connection and commissioning
(h)
(h)
13. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
14. Transfer the drill holes from the drill tem-
plate to the front panel.
15. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
16. Remove the protective films from the
other Velcro straps and stick the velcro
straps to the front panel using the drilling
template.
17. Fix the front panel to the dishwasher
door using the hook-and-loop strips (i),
hold it firmly and carefully open the door.
(k)
(k)
18. Remove the four screws from the inside
of the door. Screw the front panel in
place at these positions using the four
enclosed screws (j).
You have now fitted the front panel.
Adjusting the opening of the
door
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
To adjust the door
– so that it is easier to open, turn the screws
in an anti-clockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
