Page EN-24
Automatic control functions
Customised settings
Your washing machine’s cycle selection also
includes a “Custom” cycle. The “ECO 40–60”
cycle is configured as standard here. But you
can also store a custom cycle that you have
adjusted and would like to use frequently.
U/Min
Vorwäsche
Start/Pause
3 Sek.
Tür Entriegelung
3 Sek. drücken für Individuell
Ein/Aus
Extra
Spülen
Zeit sparen
(3)
(2)
Saving custom cycle
1. Select the right cycle and make all desired
changes (e.g. temperature, spin speed,
pre-wash, etc.). Do not start the cycle yet.
2. Press and hold the “Temperature selec-
tion” button (3) for approx. 3 seconds to
save the cycle with all changes made. The
symbol will appear to indicate that it
has been saved. The custom cycle also
remains saved after the appliance has
been switched off.
3. To change the customised settings, repeat
steps 1 and 2.
Starting custom cycle
• You can select the “Custom” cycle using
the cycle selector (2) and start as normal.
Automatic control functions
The following functions run automatically. You
cannot change them.
– Foam detection
The electronic foam detection makes sure
that more water is added to the first rinse
cycle for certain amounts of foam.
– Overflow protection system
This system prevents the water from leak-
ing out over the dispensing drawer. As soon
as a certain water level is exceeded, the
outlet pump will automatically switch on.
– Dynamic quantity control
If your washing machine is only loaded up
to half of the maximum capacity, the water
consumption and cycle duration will reduce
for certain cycles. Adjust the detergent dos-
age accordingly.
– Imbalance correction system
This system protects your washing machine
in the event of an imbalance that is too large
when spinning starts. This can happen with
small loads or with large individual pieces
of laundry. The laundry is distributed again
and the spin speed increased if the laundry
distribution is right.
