Page EN-8
Safety
NOTICE
Risk of damage to property!
Improper transport and installation
may result in damage to the appliance.
■
If a trolley is used to move the ap-
pliance, the appliance must be lifted
as shown on the packaging. Always
transport the appliance vertically.
■
Do not use any sharp or pointed ob-
jects when unpacking the appliance.
■
Do not use the loading door or the
dispensing drawer to pull or lift the
appliance.
■
Remove all packaging material befo-
re fi rst use.
■
Make sure the appliance is not
connected to the power supply whilst
the transport safety devices are being
removed or installed.
■
For rugs, carpet, parquet or wooden
fl oorboards, place a stable wooden
plate measuring at least 60 × 60 cm
underneath the appliance.
Do not stand the appliance on rugs or
carpets. Otherwise, it may not be able
to properly ventilate, which can result
in overheating and damage to it.
■
When positioning on a wooden plate
or base, these must be equipped with
indentations for the screw-on feet so
that the appliance does not migrate
off it when spinning.
■
Do not place the appliance on top of
other appliances and do not use it as
a base for other appliances (e.g. for
dryers).
■
Do not sit or stand on the appliance.
Improper handling of the appliance
can lead to water damage.
■
Do not leave the appliance unsupervi-
sed for long periods of time while the
valve is open. When draining as a re-
sult of leakiness, substantial amounts
of water may leak out.
■
Do not connect the appliance to the
cold water supply.
■
Only connect the appliance to a wa-
ter supply with an inlet water pressure
between 0.05 Mpa and 1.0 Mpa (0.5
to 10.0 bar). For higher water pressu-
re, a pressure regulator needs to be
installed. Enquire about the water
pressure with the local waterworks.
■
Close the water inlet tap after every
use.
■
Close the water inlet tap before clea-
ning the water inlet fi lter.
■
Only use the hose set delivered with
the appliance to connect to the water
supply. Do not use old hose sets.
■
Do not extend the water outlet hose
or replace it with another hose.
■
Make sure that the water outlet hose
is not kinked or twisted.
■
Be aware that substantial amounts
of water may leak out during emer-
gency draining.
■
Ensure that the water drain is not
above the maximum height (see “In-
tended use”).
■
Ensure that the water outlet hose is
in the retaining clips on the back of
the appliance so that the curvature
always remains above the waterline.
■
Do not submerge the end of the hose
in the pumped out water.
