Page EN-38
Installation, connection and initial commissioning
Getting started
Before getting started
• First read chapter “Intended use” and
chapter “Safety notices” (see page EN-4
and the following).
• Remove the transport safety devices and
prepare the appliance as described in
chapter “Installation, connection and initial
commissioning” (see page EN-34).
• Properly attach the water inlet hose (20)
and the water outlet hose (21).
Possible residual water or drops in the
appliance are merely a sign that it was
tested for functionality during production.
The appliance requires an initial wash cycle
without laundry, but with detergent (test run).
The aim of this is to rinse out possible resi-
dues from production.
1. Check whether the water inlet hose (20)
and water outlet hose (21) are securely
connected.
2. Open the valve completely.
3. Make sure that the drum is empty.
4. Push the loading door (15) tightly closed.
200
150
100
(23)
(1)
5. If the partition (23) is located in the left
chamber II of the dispensing drawer (1),
take it out. Keep it safe as it is needed
when liquid detergent is used.
6. Dispense a maximum of 25 ml of compact
detergent into left chamber II.
Aus
Wolle
Daunen
Spülen
Allergie
Extrakurz 12'
Schontrocknen
Schnell
Baumwolle
Baumwolle
Pflegeleicht
Eco 40-60
Baumwolle
20°C
Baumwolle
Kurz 60'
Schleudern/Abpumpen
//
Schleudern
Startzeit-
vorwahl
W
as
ch
en
&
Tro
ck
nen
Tro
ck
nen
Trocknungs-
zeit
Trocknungs-
stufe
Temp.
Option
Save +/
Schnell
Wh
&
(2)
(4)
(7)
7. Set the cycle selector (2) to the “Cotton”
cycle.
The cycle time is shown in the time field (4).
8. Press the button (7).
The cycle starts and the remaining cycle
time is shown in the time field (4).
After the cycle is finished, “Ende” is shown
in the time field (4).
9. Turn the cycle selector (2) to “Off”. Take
the mains plug out of the socket and turn
off the tap.
Start-up is now finished.
