Hanse VTC Series, Installation, Operation And Maintenance Instructions

Page: 41 / 91

10. The seals and gaskets on the doors floors and ports should be inspected for
adequate sealing. Remove any foreign material that may be embedded in the
gasket. Worn or damaged gasket must be replaced.
11. Check all the fasteners on the chamber and tighten, if necessary, any loose
fasteners.
12. Check the blower wheel set screws for tightness.
Daily Maintenance
The following is a list of maintenance tasks that should be performed on a
daily
basis.
1. Check the air oiler to insure that there is enough oil to provide lubrication to the
pneumatic pistons.
2. Check the bolts on the top of the vibration table to insure that they are tight.
3. Check the high and low temperature settings of the air temperature limit to
insure that they are set to the appropriate settings.
4. Make sure that the LN2 supply is on and that there is su ffi cient LN2 to perform
you’re testing.
5. Make sure that the air to the chamber is turned on.
Authorization and Copyright of this document is
controlled by Hanse Environmental Inc.
41