6
Hot tub installation
3 Hot tub installation
Attention: the hot tub must be connected pursuant to standards valid in the
Czech Republic according to ČSN 33 2000 -7-701
3 1
General information
For the installation, electrical connection and the first commissioning of the hot tub,
we recommend using the services of professionally trained technicians. If you decide
to install the hot tub yourself, follow the recommendations below.
a) Carefully remove all packing material in which the hot tub was shipped, and place
the hot tub on the site prepared for installation.
b) Remove the front panel located on the side of the hot tub control panel. Remove
the top cover of the electric switchboard, under which the circuit breaker and
residual-current device (if the hot tub is equipped with them) and the ground
terminal are located. Only a professionally qualified person may connect it to the
power cable.
c) Because your hot tub has been thoroughly tested during the production process,
it is possible that a certain percentage of dirt remains in the technological parts
of the hot tub and on its surface; we therefore recommend that you clean the
surface of the whirlpool first. Use lukewarm water to clean it. Always clean the
surface with suitable soft cloths. Never use any coarse abrasives or textiles that
could damage the surface of the hot tub. If you decide to use a cleaning product,
this product must not damage the surfaces of the hot tub.
3.2 Filling the hot tub with water
Fill the hot tub with a sufficient amount of water. The water level in the hot tub
must never fall below the level of the skimmer. If you find that there is a water leak
when filling the hot tub with water, stop filling the hot tub until the fault has been
corrected. Hot tubs do not have water softening technology and hard water damages
them. Damage caused by misuse is not covered by the warranty.
a) Fill the whirlpool through the skimmer to prevent the aeration of pumps.
b) Do not fill the hot tub with water warmer than 104 ºF.
c) When the water reaches the desired level, insert the cartridge filter into the
skimmer. When installing it, tilt the filter so that no air bubbles remain in it. After
the air has been removed, install the filter.
Summary of Contents for TP 500
Page 1: ...USER MANUAL TP 500 ...
Page 23: ...23 11 Notes Notes ...