HANSCRAFT TP 500, User Manual

Page: 13 / 24

13
The menu offers the following options:
F/C temperature display temperature switch between Celsius and Fahrenheit
12/24 time display time switch 12/24 h mode
RE-MIN-DERS reminders turns notifications on or off ( e. g. filter cleaning)
CLN-UP cleaning this function does not always have to be enabled (may not
be displayed), if enabled, you can set the operating time of
pump 1 after each use of the hot tub in the range of
0–4 hours
5.12 System information (UTILITY)
Here you will find information about the control panel. Enter the combination MENU
10× + up arrow WARM.
MENU
10×
WARM
6 Problem solutions
Most messages are displayed in the bottom left corner.
M019
Each time the hot tub is started, it enters activation mode. The purpose of
activation mode is to allow the user to start the pumps and manually verify
that they are active (air is expelled) and water is flowing. Activation mode
lasts 4 minutes, but it can be ended sooner by pressing the temperature
button. The heat pump is not switched on during activation mode.
(If your hot tub has a circulation pump, it is switched on with the Light button in
activation mode. The circulation pump starts after activation mode has ended.)
– – °F – – –°C
Water temperature unknown
When the pump has been running for 1 minute, the current temperature is
displayed.
GENERAL MESSAGES
Control panel/Problem solutions