HANSCRAFT TP 500, User Manual

Page: 12 / 24

12
Use the above combination to access the cycle start time setting. Press the up arrow
(WARM) again to display the time. Use the arrows to set the value and press MENU to
move to the next entry.
Pressing MENU again will display the text RUN HRS (filter cycle time setting). Press
the up arrow (WARM) and set the time for which the filter cycle is to be active. Set the
hours and minutes as shown above. Confirm by pressing MENU. The text
F1 ENDS and
the time when the cycle will end is displayed. Now the filtration cycle is set and will
be automatically switched on.
b) Filtration cycle 2
(MENU 8× + up arrow WARM)
Filtration cycle 2 is off in default settings. This cycle can be activated by pressing the
MENU button 8× and then using the up arrow (WARM), which will move you to the
ON
option. Filtration cycles can be set to overlap. Flush cycles, which start other pumps
to flush the piping, start automatically, always at the beginning of the filtration cycle.
5 11 Preference PREF
Here you set temperature units that the panel displays. To do so, use the combination
MENU 9× + up arrow WARM. Like this you can select the desired option, then press
MENU to confirm.
WARM
8:00 9:00
9:30
( )
WARM
( )
WARM
MENU
MENU
WARM
2:00 11:30 RUN HRS F1 ENDS
MENU MENU
MENU
8×
WARM
ON
MENU MENU
9×
WARM
SELECTION
(see following paragraph)
Control panel