21
INST
ALLA
TION
Connecting the Probe to the Flow Cell
• Remove the protective cap and verify if the O-ring (2) is in place.
Note:
The probe should be connected to the controller and calibrated before installation.
• To avoid twisting the cable, unplug probe from socket temporarily while installing in flow cell.
• Assemble the adapter fixing nut (4) with the flow cell O-ring (5) inside the adapter body (3).
Tighten the adapter enough to seal in place and not damage the O-ring (5).
• Carefully insert the probe (1) into the flow cell adapter (3), paying attention not to damage the
O-rings (2,5). Tighten the probe enough to seal in place.
• Cut the rigid PE tubing (9) to reach between flow cell inlet (bottom) and the pipe mounted outlet
valve. Push the end of the tubing (9) into the tubing fitting (8).
• Repeat the previous step for flow cell outlet pushing the tubing (7) into the elbow tubing fitting (6).
1
Probe
2
Adapter O-ring
3
Adapter body
4
Adapter fixing nut
5
Flow cell O-ring
6
Elbow tubing fitting
7
Outlet rigid PE tubing 12 mm
8
Tubing fitting 12 mm
9
Inlet rigid PE tubing 12 mm
1
2
3
4
5
6
7
8
9
OUT
IN