43
Turning the CH5 rocker, turning off the AB operation lever and cutting to the return path can interrupt
the AB operation.
The green LED flashes 4 times during execution.
During the execution, the remote control throttle channel and yaw channel can control the altitude and
heading.
4.3.3.2 point correction function
When flying from point A to point B:
Push up the pitch joystick , then pull the B point forward 1 meter,
pull the pitch joystick down, then shorten the B point by 1 meter.
When flying from point B to point A:
Push up the pitch joystick , then shorten the A point by 1 meter,
pull the pitch joystick down, then pull the A point forward 1 meter.
4.3.3.3 AB Point Parameter Settings
Open the APP and connect the UAV, click the setting button in the upper right corner, and select the plant
protection function in the left button bar to set the route spacing and speed of the AB point mode.
Figure 4-23
4.3.3.4 Others
Clear the AB points
：
Quickly toggle the AB point recording switch 4-5 times, and the LED lights flash red, green and yellow
alternately, then the AB point is cleared. The AB point cannot be re-recorded without clearing the last recorded AB
point.
Continue spraying after power off:
After the AB operation is interrupted, and the battery is replaced, if the AB operation is performed without
clearing the AB point, the last AB route of the previous job will be resumed.
4.3.4
Electric fence system
4.3.4.1 Flying restrictions and Special airspace restrictions
Summary of Contents for 3WD4-QF-10B
