21
Step 5 (Glow)
Place the hatch back into position on the bottom of the
fuselage. Use a 4-40 x 1/2-inch socket head screw and #4
washer to secure the hatch in position.
Note
: Use a small 1/4-inch (4mm)
piece of fuel tubing slide onto the
screw before installation to keep it
from vibrating loose in flight.
Step 5 (Electric)
Use a hobby knife to remove the covering from the small
hole near the magnets in the hatch. This is so you can
easily remove the hatch. Place the hatch into position on
the bottom of the fuselage.
Step 6
Use canopy glue to secure the canopy to the fuselage.
Use masking tape to hold the canopy in position until
the glue fully cures.
Step 7
Attach the wing to the fuselage using two
1/4-20 x 2-inch nylon bolts.
Section 4: Final Assembly
