20
Required Parts
• Fuselage
• Wing
• Canopy
• Hook and loop strap
• 1/4-20 x 2-inch nylon bolt (2)
Required Tools and Adhesives
• Canopy glue
• Flat screwdriver
• Masking tape
• 1/4-inch foam
• Hobby knife
• Receiver
• Receiver battery
• Switch harness
Step 1
Wrap the receiver and receiver battery in 1/4-inch foam to
protect them from vibration.
Step 2
Plug the throttle, elevator and rudder servo leads, as well
as the switch harness, into the receiver. Route the receiver
antenna to the rear of the fuselage. A tube has been pre-
installed for routing the receiver antenna wire.
Step 3
Place the receiver (both electric and glow) into the
fuselage on the top of the plywood tray. Use a hook and
loop strap to secure the battery to the tray as shown.
Note
: When using an electric motor
and a receiver pack, place the pack
underneath the receiver to provide
more room for the motor batteries.
Note
: In glow applications, the receiver
battery is placed on the bottom side of the
plywood tray, and the strap will go around
both the receiver and receiver battery.
Step 4
Mount the switch harness in the side of the fuselage. The
switch should be on the opposite side of the muffler when
using a glow engine.
Section 4: Final Assembly
