11
Required Parts
• Landing gear w/wheels
• Fuselage
• 1-inch (25mm) tail wheel • Rudder assembly
• Stabilizer assembly
• 4-40 locknut (2)
•#4 washer (large) (2)
•#6 washer (3)
• 5/64-inch wheel collar
• 4-40 setscrew
• 6-32 x 3/4-inch machine screw (3)
• Pre-assembled 4
1
/
2
-inch (114mm) linkage (2)
Required Tools and Adhesives
• Servo w/hardware (2)
• Long servo arm (2)
• Adjustable wrench
• Threadlock
• 18-inch (458mm) servo extension (2)
Step 1
Attach the landing gear to the bottom of the fuselage
using three 6-32 x 3/4-inch machine screws and three #6
washers.
Note
: Use threadlock on the screws to
prevent them from vibrating loose in flight.
Step 2
Slide the threaded rods from the rudder assembly into the
holes in the stabilizer. The two forward rods go through
the stabilizer as shown.
Step 3
Slide the rudder/stabilizer onto the fuselage. Guide the
threaded rods through the stabilizer saddle then through
the holes in the bottom of the fuselage.
Section 2: Landing Gear and Tail Installation
