31
Installing the Rudder, Elevator, and Throttle
Servos
❑
1. Locate the other three servos and install the grommets
and eyelets in all three per the instructions included
with the radio. Place the servos in the servo tray in the
fuselage as shown, noting the position of the output
horns. Using a pencil, mark the 12 servo mounting hole
positions.
❑
2. Remove the servos and drill twelve 1/16” holes where
marked. Install the servos, noting the position of the
output horns. Screw in place with the 12 screws
included with the servos.
Installing the Receiver and Battery
❑
1. Radio packing foam (available at your local hobby
shop) should be used to install the receiver and battery.
With a sharp hobby knife, cut a layer of foam the size of
the compartment in front of the servo tray and place it
in the bottom of the fuselage. Then, cut out another
layer of foam and cut out the center section to match
your battery pack.
❑
2. Cut out another layer of foam and place it on top of the
battery. Cut out the next layer so that it clears the
receiver. You then have a solid top layer over the top of
the receiver.
Important:
Run the antenna through the fuselage and out the rear.
Section 13: Installing The Radio
CONTINUED
Summary of Contents for Easy Fly 40
Page 47: ...47 ...
Page 49: ... Copyright 1994 Horizon Hobby Distributors Inc ...
