NEEDLE THREADER ADJUSTMENT
1. If you need to change the
needle threader pull the shaft
down gently and push down on
the threader gently and
remove it.
2. If the height of the threader is
off to the needle, then turn the
hand wheel slightly to expose the
threader block on the needle bar.
Loosen the block with a 2 mm hex
driver and either move it up or
down to get the correct height.
Do
not rotate the block when
adjusting it up and down
. Then
tighten the screw.
3. If the left to right position is off
then take a small philip’s head
screwdriver (
QM10273 from HQ
Stitch Tool Kit SM49280)
and
loosen the screw and move the
threader pin either left or right to
get the correct position.
37
