Hand Held Products SCANTEAM 2070 BASE, Manual

Page: 14 / 132

Cordless System Manual
1–4
Proper Disposal of the Battery Pack
When the battery pack has reached the end of its useful life,
the batteries should be disposed of by a qualified recycler or
hazardous materials handler. Do not incinerate the battery
pack or dispose of the battery pack with general waste
materials. Contact the Product Service Department (see
page 9–1) for recycling or disposal information.
Cordless
Scanner
Charge the Battery Pack by following the steps shown below:
Rechargeable
Battery Pack
➊
Fully charge the battery (see page
1–3). Plug the battery pack directly
into any common 120 Volt AC outlet
in North America. If outside North
America, use the custom charge
strip.
➋
The LED on the bottom of the battery pack lights
red when the unit is charging; it shows green
when it is fully charged and ready to use.
Charging Your Battery Pack
Note: It is important that you charge the battery for
24 hours prior to the first use. No damage
occurs if this is not done, but the battery
capacity will not be 100%.
Recharge Time:
4 hours at any voltage at 20 C (68 F).
➌
After the battery pack is fully charged, attach it to the Cordless Scanner by
pressing the pack firmly (align the prongs on the pack with the mating
receptacles) in the base of the scanner until the release buttons click, holding
the pack firmly in place.
(When you attach a charged battery pack to the
Cordless Scanner, you will hear a single beep.)
➍
If you haven’t set up your Cordless System, turn to the next page for
instructions.
When the battery pack needs recharging, the yellow LED on top of the scanner
pulses in short, continuous blinks and the scanner won’t beep when you pull
the trigger. If the LED stops flashing when the temperature lowers or you do
not use the battery pack for some time, you still need to charge the battery
pack to avoid damaging the battery pack or causing scanner memory loss.