2 - 1
2
Quick Start & Interface Menu
Introduction
Use this section to program the cordless system to work with your terminal or
computer (host system).
This programming section contains the following menu selections:
• Plug and Play
• Terminal Interface
• Country Code
• Keyboard
• Output Delays
• Wand Emulation
• Power Settings
• Reset Factory Settings and Status Check
All operating parameters are stored in nonvolatile memory resident in the
cordless system, where they are permanently retained in the event of a power
interruption. When you receive your cordless system, certain operating
parameters have already been set. These are the factory defaults, indicated by
an asterisk (*) on the programming pages (beneath the default programming bar
code). Default Charts that list all the factory settings may be found near the end
of this System Manual.
A Programming Chart (found on the inside back cover of this manual) contains
alphanumeric bar codes for setting additional programming options, such as the
digits representing Symbology Message Length. The chart explains how and
when to use the alphanumeric bar codes.
A Sample Bar Codes pages (located near the back of this manual) provides bar
code symbols you may scan to verify that your cordless system has been
programmed correctly and is communicating with your host system.
Summary of Contents for IMAGETEAM 3870
