![background image](http://html1.mh-extra.com/html/han-bond/hb-series/hb-series_user-manualline_3483091057.webp)
www.han-bond.com
56
Make sure the cutting material covered the entire table, if the table cannot be
covered which will lead to "leak" make the cut object adsorption is not tight;
Problem three: after cutting the graph is not normally taken down (not
cut completely).
Failure analysis and solution:
Check the cutting pressure, can through the cutting pressure to adjust;
Take off knife holder, check the knife is blocked and clean up debris;
According to the cutting material to re- adjust the length of blade tip, If the
tool nose wear seriously can appropriate expend the tool nose;
According to the cutting effect and use requirements, can choose to replace a
new blade;
Problem four: when you click on the output, the machine does not work.
Failure analysis and solution:
Check the USB line in the end of computer and machine connection is normal
or not;
Check the USB line driver installation is normal, whether it is disabled, please
refer to the manual of the fourth chapter;
Check whether the output center setting is correct, as instruction shown in
section 5.5.2 of this manual;
Summary of Contents for HB Series
