Han-Bond HB Series, User Manualline, Page: 53 / 58

www.han-bond.com
52
The second step: take (Figure 16) "B reference position as an example, when
the cutting line in the jet line below, it needs to decrease the control panel item 6
[X axis coincidence set] the corresponding value, contrary to increase numerical;
Complete the debugging of X, Y axis of the coincidence set
Continue to print the file "pettifoggery coincidence settings file”, start
debugging pettifoggery scaling.
Note: reference “E reference position”, (as shown in Figure 17) after
adjusting the X/Y axis coincidence set, then you can to carry out this operation.
Figure 17 pen knife coincidence cutting effect chart two
("---black line" is ink jet lines, --- "red line" is cutting line)