9
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Assembly (continued)
Install
Insert
From
Back
Completed
Unit
Electric
Fireplace Insert
Remove the two mounting brackets attached to the
back of the Left and Right Front panels, and set aside.
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert across
Hearth/Base (A) as it may scratch your unit.
Install the mounting brackets to hold insert flush
against the inside of the mantel front panel.
6
Insert installation
NOTE:
Please read all “electric fireplace insert”
instructions prior to installing electric insert in your completed
fireplace mantel. Install the insert in your fireplace close to its
final position.
NOTE:
Use great care to move your completed unit. Move
it only short distances, and use two people to move it into its
final position.
CAUTION:
Cold climate installation recommendation: When installing this unit against a non-insulated exterior wall or chase, it is
mandatory that the outer walls be insulated to conform to applicable insulation codes.
CAUTION:
A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a dedicated
circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The
unit comes standard with 6-ft. three-wire cord, exiting from the rear of the fireplace. Avoid using an extension cord. If an extension cord must
be used, it must be a minimum 14 AWG, three wire with grounding type plug connector and rated not less than 1875 watts. Do not use an
extension cord more than 20 ft. in length.
