Hammond XK-3C, Owner'S Manual

Page: 64 / 126

*#1 :-%
Owner’s Manual
64

EXPRESSION
10. EXPRESSION - SOURCE (G)
Determines what to use for controlling the Expression.
PED1(NORM) PED1(NORM) PED1(NORM) PED1(NORM) PED1(NORM):
Uses V-20R etc.
PED1(REV) PED1(REV) PED1(REV) PED1(REV) PED1(REV):
Uses KORG XVP-10 etc.
EXP EXP EXP EXP EXP-100 -100 -100 -100 -100:
Uses EXP-100F.
MIDI IN MIDI IN MIDI IN MIDI IN MIDI IN:
Uses the Expression Information received at the keyboard channel UPPER.
11. EXPRESSION - MONITOR
Displays the present Expression Value. You can find the causes for such troubles as “no
sound”, “non-function” of the Expression Pedal, by checking if the Expression Value
changes normally. Also, this can be a guide when you want to play the “fade in” from
“quiet”.
12. EXPRESSION - MINIMUM LEVEL (G)
It sets the output level when the Expression is minimum.
The setting range is OFF, -40db to 0db. “OFF” makes no sound when the Expression is
minimum, “0dB” does not reduce volume level.
13. EXPRESSION - LIMIT LF (G)
14. EXPRESSION - LIMIT HF (G)
These are for setting the level to maintain for low and high frequencies when the Expres-
sion is minimum.
The setting range is OFF, -40dB to -5dB. This function does not work at “OFF”. Other-
wise the level is maintained even if the Expression is minimum.
15. EXPRESSION - GAIN (S)
This is for adjusting the gain (=range of the change) of the connected expression pedal.
It sometimes occurs that even if you press the expression pedal to the bottom limit, the
expression value does not reach the maximum value (127) due to the difference of each
expression pedal model. In such a case, adjust this parameter for getting the maximum
range.
16. EXPRESSION - CURVE (S)
This parameter sets how the value should vary corresponding to the depth of the expres-
sion pedal. The setting range is 1 to 3. Refer to the curves on the bottom right figure.
NOTE: These parameters are System Parameters. These parameters will be recorded when
set. It is common in each Combination Preset. It is not recorded to the “Setup”.
 FOOT SWITCH
17. FOOT-SWITCH - 1 DEVICE (G)
This is for deciding which equipment is connected to the Foot Switch 1 jack.
PED PED PED PED PEDAL AL AL AL AL: for Foot switch.
CU-1 CU-1 CU-1 CU-1 CU-1: for the Leslie switch CU-1 (= optional).
EXPRESSION LIMIT
One of the human ear’s characteristics is that when
the volume falls, the sound of high or low frequency
becomes difficult to hear.
On this model, it is rectified. The volume is main-
tained above a certain level even when the volume
goes down in order to keep the sound of high or
low frequency audible.
The similar function is adopted on most home au-
dio equipments. It is called the “loudness” func-
tion.