40
Maintenance
3.
Switch machine off with the red
[Stop]
button.
The saw shaft with clamped saw blade must be brought to a complete stop
within 10 seconds.
Machine comes to a standstill within 10 seconds.
1.
Checking the time for the machine to come to a stop com-
pleted.
Machine takes longer than 10 seconds to come to a standstill.
1.
If present: Switch off
[Main switch]
(position
"O" / "OFF"
).
2.
Disconnect the machine from the mains power supply.
3.
Contact Felder-Group service centre.
3.4.6
Check effectiveness of safety devices (end switch)
Note
The saw blade only operates if the limit switch inside the machine
frame has not been actuated (insert board must be inserted).
In the event of any problems or malfunctions, please contact a
member of the Felder Group service centre.
Ensure that the safety break switch is working properly
1
2
3
4
Fig. 32: Safety limit switches - Insert board
1 Insert board
2 Rear flange
3 Green start button - Saw blade ON
4 Limit switch
1.
Switch off the machine and secure it against being switched on again.
2.
Preparing the machine for a tool change.
3.
Remove the insert board, saw blade and rear flange.
Summary of Contents for K2 M
Page 55: ......
