MTS SHOULDER PRESS Assembly Instructions
12
5 POUND
INCREMENT
WEIGHT
10
20
30
40
50
60
70
80
90
110
120
130
140
150
100
Line up arrow on increment weight sticker
with center of knob on increment weight.
Peel off backing on weight plate number
sheet and line up edge with holes. Press on
numbers and remove top paper.
Assembly Figure 10. Label details for MTS SHOULDER PRESS.
To apply the weight plate stickers:
1. Peel off the backing.
2.
Line up sticker backing edge with holes as shown in the figure
.
Make sure you’ve aligned the sheet so
that the top hole in the stack (the one that holds the weight stack pin) DOES NOT get a sticker
.
3. Make sure the sheet of labels is straight.
4. Press
down.
HAMMERHEAD WASHER LOCATIONS
on both sides
Assembly Figure 11. Hammerhead washer locations (6 total).
Assembly Figure 11 shows the bolt connections on the MTS SHOULDER PRESS that need hammerhead
washers. There are 6 hammerhead washers that need to be installed in the field. They are found on the back
frame seat connection (2) and on the side/back frame connection (4). Hammerhead washers on the shields
and arms have been installed at the factory.
