Hammer Strength MTSP, Unpacking And Assembly Instructions

Page: 18 / 18

MTS SHOULDER PRESS Assembly Instructions
18
5. PREVENTIVE MAINTENANCE TIPS
ACTION DAILY MONTHLY QUARTERLY BI-ANNUALLY YEARLY AS NEEDED
CLEAN
Upholstery X
Guide Rods
X
Linear Rods X
Shields
X
Hand Grips X
INSPECT
Belts X
Hardware
X
Frame X
Hand Grips
X
LUBRICATE
Linear Bearing X
Guide Rods
X
Range Limiter X
Clean:
•
Upholstery with a mold soap and water.
•
Guide and linear rods with a cotton cloth.
•
Hand grips with mild soap and water.
Inspect:
•
Belts for wear or damage and proper tension (should not exceed ¾” deflection). Pay close attention at
bends and attachments points.
•
Hardware should be checked for looseness. Tighten as required.
•
Frames should be inspected for wear or damage.
•
Hand grips should be checked for wear or damage.
Lubricate:
•
Linear bearing with TF1000 grease (part number SK50-P0004-0000).
•
Guide rods with Break-Free (part number SK50-P0005-0000). Apply the Break-Free to a cotton cloth, then
run the cotton cloth up and down the guide rods as needed.
•
Range limiting device should be cleaned and lightly oiled using Break-Free (part number SK50-P0005-
0000).