15
Hammer Engines GmbH / IQ-Serie / Instruction Manual
Status readouts / the order of readouts on this page corresponds to the
order they occur in during the startup sequence
OFF
Turbine off, waiting for Standby
STANDBY
Standby – waiting for Startup Sequence. (Throttle stick and throttle trim at 0%, then both
opened up to 100%)
PRE Heat
The turbine is pre-heating
BURNER ON
The burner is on
FUELIGNIT
Fuel is being ignited
BURN OUT
Excessive fuel is being burned off
RAMP UP / F-Pulse
Turbine revs up to idle
STEADY
Waiting for stabilization of turbine RPMs
CAL IDLE
Idle is being adjusted
CALIBRATE
Calibration rpm is being adjusted
WAIT ACC
Waiting for end of ramp up
STEADY
Waiting for stabilization of turbine RPMs
GO IDLE
Calibration of idle rpm
AUTO 4,7 V
(Value differs depending on the turbine used)
AUTO-HC
Turbine in automatic mode – top rpm have been adjusted – mandatory to enable failsafe in
case of sensor failure
