Document #101-0008
5
11/11/05
II. INSTALLATION
Front Load Cabinet
The Stacker is attached to the rear of the cabinet by three screws, or on a Stacker Hanging Bracket, depend-
ing on the cabinet model. If using a Stacker Hanging Bracket, position the upper two holes in the Stacker over
the top two screws and install the lower screw. Hook the Validator Mounting Bracket onto the mounting pins
of the Stacker. Attach the Validator Support Bracket to the Validator Mounting Bracket and to the side of the
cabinet. Connect the Validator and Stacker wiring harnesses. Place the Validator in the Validator Mounting
Bracket.
Rear Load Cabinet
Place the Validator Wiring Harness over the top of the Validator to protect it during installation of the Stacker.
Connect the Stacker wiring and place the wiring above the Stacker to protect it during installation. Place the
Stacker just behind the Validator with the housing support pins slightly above the Validator Support Bracket
and move the Stacker forward to contact the Validator bracket. Move the Stacker forward and down until the
Stacker housing support pins rest in the slots of the Validator Support Bracket.
Proper operation of the Stacker requires it to be hanging vertically
at this point.
The mounting system for Rear Load Changers equipped with a Stacker consists of a main bracket that bolts to
the front of the changer cabinet and two side plates that are fastened to either side of the Validator. The
Validator and plates slide into the main bracket and are secured. The Stacker is then hung on tabs provided on
the side plates.
