Hamilton Hopper HSH, Manual

Page: 11 / 28

Document #101-0240 11 04/22/2013
VIII. HOPPER RUN TEST
The Hopper Run Test is a test that can be used to determine if a Hopper is counting coins correctly.
Hamilton Hopper
1. Obtain a large number of coins (500 if possible) that the Hopper is configured to
dispense, and count them carefully to determine the exact number of coins.
2. Empty Hopper completely and make note of the count on the Hopper’s mechanical
counter.
3. Dump in all of the counted coins and turn the Manual Run Switch to the “ON” position.
Run the Hopper until every coin has been dispensed.
4. Check to see if the Hopper’s mechanical counter matches the previous count plus the
number of coins that were just dispensed.
5. Repeat the test as necessary.
Smart Hopper
1. Obtain a large number of coins (500 if possible) that the Hopper is configured to dispense
and count them carefully to determine the exact number of coins.
2. Empty Hopper completely.
3. Connect Handheld to Hopper.
4. Press F2 to display “Show Counters”. Make note of the “Temp” number.
5. Dump in all of the counted coins
6. Press F1 to display “Manual Run” options.
7. Press F2 to determine the amount of coins to be dispensed in “Edit Dispense #”. Then
using the keypad numbers enter the amount of coins to be dispensed. (i.e. 250)
8. Press F1 to “Dispense XXX”
9. Hopper will dispense the selected amount of coins
10. Once dispensing is complete then Press F2 to display “Show Counters”
11. Check the “Temp” totals to verify the correct count.