www.hameco.eu
HV-100E User Manual
hameco
9
5. IE LOGIN AND TRACK SETUP PROCESS
5.1 Connecting Mode
Direct connection:
Connect the camera via network cable to external Internet access of the PC Internet
Connection mode:
Connect the camera to Internet by Router or Switch and user can log in the device
by browser.
Note: Please do not put the power and network cable in places where can be easily touched to
prevent video quality lowered by unstable signal transmission due to poor contact of 8 cables.
The computer must have the network segment where the camera IP address belong to. The device will
not be accessible if without the segment. I.E. The camera default IP address is 192.168.5.163, then
segment 5 must be added in the computer. Specific steps are as below:
Firstly open the window of Local Area Connection Properties on computer, select the “Internet protocol
version 4(TCP/IPv4)” as shown by picture on the left. Double click or click the property “Internet” pro
-
tocol version 4 (TCP/IPv4)to enter into the Internet Protocol Version 4(TCP/IPv4) Properties window,
select “Advanced” to enter into the Advanced TCP/IP Setting and add IP and subnet mask in the IP
browser as picture shown below. Click the “Confirm” to finish the adding of IP segment. User can add
the corresponding network segment according to the revised IP address of the camera.
Note: The IP address to be added cannot be same with that of other computers or devices.
The existence of this IP address needs to be verified before adding.
To verify whether the network segment has been successfully added, click the “Start” and select
“Operation” to input cmd, then click OK and open DOS command window, type ping 192.168.5.26,
press Enter key to display information shown below, which means network segment
adding is
succeeded.
