14
00176566
Status light
Reset
Speaker
Micro USB
Microphone
SD card slot
4.6.1 Product features
•
Status LED is constantly lit red: Preparing for pairing
mode
•
Status LED flashes red: Pairing mode active (device can
be connected)
•
Status LED flashes blue: QR code was recognised
•
Status LED is constantly lit blue: Connection set up
successfully
Note
•
Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
•
Connect the product only to a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
•
Do not attempt to service or repair the product yourself.
Leave any and all service work to qualified experts.
•
Do not continue to operate the device if it becomes
visibly damaged.
•
The product is intended for indoor use only.
•
Keep this product, as all electrical products, out of the
reach of children!
4.6.2 Installation
•
You can attach the camera using adhesive pads.
•
Power can be supplied to the camera only via USB.
•
For USB operation, connect a Micro-USB cable (included
in delivery) to the Micro-USB port and to a suitable USB
power supply (included in delivery). Plug the power
supply unit into a socket. Connect the product only to a
socket that is approved for the device. The socket must
be installed close to the product and must be easily
accessible. When powering the device using a USB
power supply, make sure there are no batteries inside
the device.
Warning - Installation with adhesive pad
•
All parts are intended for indoor use only. Do not
install them outdoors.
•
Please note that the installation surface you choose
should be free of dust and grease. Use a suitable clean-
ing agent from a specialised dealer to clean the surface.
•
Note that the adhesive pad attachment is permanent.
To remove the adhesive pad, carefully pull it off the
installation surface.
•
Various environmental factors such as ambient
humidity, sunlight or cold can impair the durability of
the adhesive pad.
•
We cannot guarantee that residue will not be left on the
mounting surface after the adhesive pad is removed.
4.6.3 Integrating devices into the Hama Smart
Solution app
•
Connect the WiFi camera to the USB cable supplied and
the power supply unit. Plug the power supply unit into
a socket.
•
Wait a moment until the camera emits a signal tone and
the
LED
begins to flash
red
.
•
Open the app and tap ‘
My home
’ at the lower-left edge
of the screen.
•
Then tap ‘
+
’ at the upper-right edge of the screen, select
the ‘Cameras’’.
•
Tap ‘
OK
’ to confirm that the camera is flashing.
•
Then enter the name of your WiFi network and the
password. Tap ‘
OK
’ to confirm your entries.
•
Now scan the QR code with the camera. Tap ‘I heard
the beep’ to confirm that you heard a signal tone. The
camera will now be connected.