Supplied By www.heating spares.co Tel. 0161 620 6677
10
97mm - CBX 24/32 & SBX 30
105mm - CBX 38
225.2
225.2
150
POSITION OF
DUCT HOLE
POSITION OF WALL
MOUNTING PLATE
2.5º
97mm - CBX 24/32 & SBX 30
105mm - CBX 38
11(a) REAR FLUE
11(b) SIDE FLUE
MOUNTING THE APPLIANCE
4.3
Refer to Figure 11
a)
Lift the appliance into position approximately 10 mm above the top
of the wall mounting plate and use the side wings on the plate to
locate the appliance horizontally. Then carefully lower the
appliance, ensuring that the top locating tabs are securely engaged.
b)
Connect the central heating system pipes to the central heating flow
and return pipes on the boiler.
Pipe work may be routed from above or below the
appliance as required.
CENTRAL HEATING & DOMESTIC HOT
WATER SERVICE CONNECTIONS
4.4
Refer to Figure 12
Commission the central heating system and domestic hot water system,
for CBX appliances as described in section 5.1, and then proceed to
Section 4.5.
11
MOUNTING THE APPLIANCE
SIDE WINGS
LOCATING TABS
LIFTING POINT
12a
CBX SERVICE CONNECTIONS
12b
SBX SERVICE CONNECTIONS
SERVICE
CONNECTION
PIPES NOT
SUPPLIED
CENTRAL
HEATING
RETURN
MAINS
WATER IN
& FLOW
TURBINE
GAS
SUPPLY
DOMESTIC
HOT WATER
OUT
CENTRAL
HEATING
FLOW
FILLING
LOOP
DRAIN
POINT
PRESSURE
RELIEF
CONDENSATE
OUTLET
43mm
108mm
169mm
240mm
305mm
351.5mm
411.5mm
448mm
43mm
169mm
240mm
305mm
351.5mm
411.5mm
448mm
SERVICE
CONNECTION
PIPES NOT
SUPPLIED
CENTRAL
HEATING
RETURN
GAS
SUPPLY
CENTRAL
HEATING
FLOW
DRAIN
POINT
CONDENSATE
OUTLET
SECONDARY
RETURN
FROM
TANK
(OPTIONAL)
PRESSURE
RELIEF
18
751030 MANUAL (NEW) 21/9/10 08:43 Page 38
