Page 6
1000004727 (Rev. A - 09/18)
HAC-HB*1C HAC-HB-NF-*1C
1) Connect Water Supply:
•
Remove the in-line strainer outlet tube from
the Regulator Inlet.
• Remove the 1/4” copper tubing from the
Regulator Outlet.
•
Connect the in-line Strainer Outlet using 1/4”
poly tubing to the Evaporator 1/4” copper
inlet using the supplied 1/4” union.
2) Add water supply to Bottle Filler:
•
Cut the Evaporator outlet 1/4” poly tubing
6” from the Evaporator Outlet and insert
the 1/4” Tee fitting between the two pieces.
• Connect Bottle Filler supply line to tee fitting.
• Remove 1/4” poly tubing from Bubbler.
3) Re-route water supply to Regulator Inlet:
•
Insert end of 1/4” poly tubing from the
Tee fitting to the Regulator Inlet which is
marked with the word “IN” on the regulator.
4) Connect water supply from Regulator to Bubbler:
•
Cut a 12” piece of 1/4” poly tube along with
matching length of insulation.
•
Insert 1/4” poly tube into insulation.
•
Insert 1/4” poly tube into the Regulator
Outlet (unmarked).
•
Opposite end of 1/4” poly tube will be
inserted later into the Bubbler.
RE-PLUMBING SINGLE STATION WATER CIRCUITS (NON-FILTER)
CAUTION:
•
This procedure MUST be performed on ALL SINGLE HALSEY TAYLOR WATER COOLERS or the bottle
filling unit
WILL NOT perform properly!
•
When disconnecting water lines use a container to catch any water running out of the lines.
IN-LINE
STRAINER
REGULATOR
1/4”UNION
REGULATOR
TEE
TO BOTTLE
FILLER
6” TUBING
EVAPORATOR
INLET
EVAPORATOR
OUTLET
EVAPORATOR
OUTLET
EVAPORATOR
STANDARD HAC PLUMBING
HAC Hydroboost PLUMBING
Fig. 2
IN-LINE
STRAINER
12” TUBING
B
C
A
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
OPERATION OF QUICK CONNECT FITTINGS
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
RELEASE TUBE
OPERATION OF QUICK CONNECT FITTINGS
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
RELEASE TUBE
A
B
C
TO BUBBLER
TO BUBBLER
EVAPORATOR
EVAPORATOR
INLET
