Page 2
1000004727 (Rev. A - 09/18)
HAC-HB*1C HAC-HB-NF-*1C
WATER COOLER PREPARATION
3) Remove Basin Fasteners
• Remove Basin Assembly by loosening eight (8)
screws, four on each side of basin.
Remove Front Panel
Loosen Drain Line
Remove Basin Fasteners
1) Remove Front Panel
•
Remove lower front panel of water cooler by removing
the four (4) screws, two at top and two at bottom. On
Two Level Models, remove both front panels.
•
WARNING: Before proceeding.
Disconnect electrical power supplying the water cooler.
Switch circuit breaker “OFF” or remove fuse.
•
Unplug water cooler power cord from electrical
outlet.
•
Shut off water supply.
NOTE:
• On Two Level Models, the Bottle Filling Unit can be mounted to the higher or lower unit:
• Two Level Standard Models; high unit is on Left Hand(LH) side.
• Two Level Reverse Models; high unit is on Right Hand(RH) side.
2) Loosen Drain Line
• Loosen Slip-Joint Nut at P-trap.
• Note: Have container/bucket readily available to catch
water from lines.
4) Remove Bubbler Water Line
• Disconnect water line from bubbler.
Remove Bubbler Water Line
