FoamLogix, Model 2.1A and 1.7AHP Class
“A”
Electronic Foam Proportioning Systems
73
The COM LED indicates the module’s CAN communication status.
On Solid
= Module on-line
Flashing slow (2Hz)
= CAN bus okay, but the module is not receiving messages from the Foam Controller.
Flashing fast (8Hz)
= CAN bus error, no communications.
Gray connector (this connector is the same between the old and new motor drivers)
Mating connector:
Deutsch DT06-12SA GRAY
Mating sockets:
Deutsch 0462-201-16141
Gold mating sockets:
Deutsch 0462-201-1631
Recommended wire gage:
16-20 AWG
Wedge lock:
W12S
PIN
CIRCUIT
DESCRIPTION
1
SYS POWER
(INPUT)
–
B
attery voltage (+9VDC…+32VDC)
2
CAN HIGH
(DATA)
–
SAE J1939 CAN 2.0B, 250Kbits/s
3
CAN SHIELD
(DATA)
–
SAE J1939 CAN 2.0B, 250Kbits/s
4
TANK A ACTIVE
(INPUT)
–
Positive polarity
5
TANK B ACTIVE
(INPUT)
–
Positive polarity
6
TANK A LOW
(INPUT)
–
Positive polarity
7
TANK B LOW
(INPUT)
–
Positive polarity
8
FOAM SENS PWR
(OUTPUT)
–
Reference voltage for foam sensor (battery power)
9
FOAM SENS SIG
(INPUT)
–
Positive pulse signal
10
FOAM SENS GND
(OUTPUT)
–
Battery ground
11
CAN LOW
(DATA)
–
SAE J1939 CAN 2.0B, 250Kbits/s
12
SYS GROUND
(INPUT)
–
Battery ground
Pump/Motor
Figure 4 610-00044 pinouts
Summary of Contents for FoamLogix 1.7AHP
