HAKO 7580.02, Service Booklet

Page: 7 / 116

Foil 7
The Hakomatic B 1100 and the Hakomatic B1050 are equipped with a service indication
in the hourmeter display. Upon switching the key switch ON, a 4-digit code describing
the software version (e.g. 3.018), is displayed for about 3 seconds, followed by another
4-digit code signalling the last error which again is followed by the hourmeter indication.
Upon launch of the Hakomatic B1050, software version has updated to 4.020.
With the software revision 4.026 the Hakomatic B1100 TB 1230 was introduced.
As soon as a malfunction occurs, the red LED signalling a defect lights up and a warning
buzzer sounds. The current error code appears (as 4-digit alpha-numeric code in the
service display) with blinking dots between the digits. When all these criteria are met,
the error is a current one!
There is
NO
error code, containing a “0”.
Find the error codes listed in a table in chapter 11.
This document uses the following abbreviations:
TSG - low discharge signal sender
SWA - dirty water recycling
2. General