![background image](http://html1.mh-extra.com/html/hakko-electronics/fm2022-02/fm2022-02_instruction-manual_3318347009.webp)
8
■
Checking the connection
cord for breakage (Refer to
P.11 WIRING DIAGRAM of A
side. )
1. Remove the soldering tip and the handle.
2. Measure the resistance values between the
connector and the lead wires at the socket
as follows:
Pin 7 - (1)
Pin 2 - (3)
Pin 4 - (4)
Pin 8 - (2)
If any value exceeds 0
Ω
or is
∞
, replace the
FM-2022.
A side socket
(2)(inside)
(3)
(4)
(1)
9. TROUBLESHOOTING GUIDE
WARNING:
Disconnect the power plug before servicing.
Failure to do so may result in electric shock.
CHECK
: Is the power cord disconnected?
ACTION : Connect it.
CHECK
: Is the tip inserted properly?
ACTION : Insert the tip completely.
CHECK
: Is the connection cord and/or the
heater/sensor broken?
ACTION : See the appropriate section of this
manual regarding how to check the
connection cord and/or the heater/
sensor for breakage.
●
The tip does not heat
up.
• The sensor error
is dis-
played.
●
Solder does not wet the
tip.
CHECK
: Is the tip temperature too high?
ACTION : Set the appropriate temperature.
CHECK
: Is the tip contaminated with oxide?
ACTION : Remove the oxide by cleaning the tip
on a damp sponge of Hakko 599B tip
cleaner.
●
The tip temperature is
too high.
CHECK
: Is the connection cord broken?
ACTION : See “Checking the connection cord
for breakage”.
CHECK
: Is the entered tip identification
number correct?
ACTION : Enter the correct value.