4
6. OPERATION
●
Controls and displays
Please refer to the FM-202 instruction
manual.
CAUTION:
Refrain from inserting foreign objects, the
wrong end of the tip, or incompatible tips into
the process gate. Damage may result.
NOTE:
If the buzzer sounds three times when the tip
is inserted into the process gate, there has
been a reading error. Reinsert the tip. If the
Tip ID is torn or damaged the process gate
will not be able to read it. See the FM-202
manual for instructions on manually entering
the Tip ID.
FM-202
Soldering station
Process gate
Receptacle
NOTE:
This procedure must be followed EVERY
TIME THE STATION IS TURNED ON.
Display
Setting temperature
TIN error
LED lamp at the connector begins to flash.
Turn the switch ON.
and
NOTE:
The tips are a set of 2 pieces with the same
Tip ID. They must be used together.
There is a flange.
Make sure that the flange will
fit the handle when inserted
into the handpiece.
●
Displays
1. If tips are in the handpiece, remove
them.
2. Turn the power switch ON.
3. The display will show
and the
LED on the connector will flash.
4. Enter Tip ID as follows:
Insert the Tip ID end of one of the tips
into the process gate until the buzzer
sounds once. Tip ID data are dis-
played for one second. The display
shows
.
5. Inserting the tip:
Hold the head part of the tip with the
heat resistant pad and insert the tip
into the handpiece. Push until the tip
stops. Repeat for second tip.
