![background image](http://html1.mh-extra.com/html/hakko-electronics/852/852_instruction-manual_3307226010.webp)
1
2
3
4
(Figure 1)
(Figure 2)
(Figure 3)
(Figure 4)
OPERATION
Auto/Remove Mode
●
Selecting Remove Mode
Press the mode selection button and set the
mode to REMOVE. This mode has the
following sequence:
①
Start/hot air blow (manual)
②
Vacuum ON five seconds before the timer
runs out (automatic)
③
Vacuum OFF (manual)
④
Cooling start and air blow stop
(automatic)
●
Removal
●
Preparation
Position the nozzle and pads over the part
you wish to remove.
①
Start (heating)
Press the start button on the handpiece
(or the foot-switch). Hot air blows from the
nozzle and melts the solder. The timer
begins counting down. (Figure 1)
CAUTION
To stop the program, press the start button. Cooling
begins.
②
Suction
When five seconds remain on the timer,
the vacuum automatically turns ON and
the part is held by suction. Lift the
handpiece and remove the part from the
P.W.B.. (Figure 2)
③
Releasing the Part
Release the part by pressing the vacuum
button for more than 0.3 second.
(Figure 3)
④
Stop
When the timer reaches 0, cooling begins
and the air stops blowing as soon as the
temperature reaches 200°C. (392°F.).
VACUUM
MODE
POWER
TIME
TEMP
OFF
ON
To check the temperature setting,
press the
button for less than
one second. To change the temper-
ature setting, see “Setting/Chang-
ing the Temperature” on page 11.
To change the air blow
time, see “Setting/
Changing the Time”
on page 12.
CAUTION
If the vacuum button is pressed before the timer runs down to
five seconds, the vacuum pump turns ON and the remaining time
is automatically set to five seconds.
CAUTION
The solder that remains on the substrate will be deteriorated.
Remove it with a solder remover or some solder wick.
9