37 / 48
Hakki Pilke 43 Pro
Translation
Version 6-2018
5.4.2.
Replacing and tensioning the out-feed conveyor belt
The instructions for tensioning and aligning the out-feed conveyor are presented in Section 4.4.
Replace the out-feed conveyor belt as follows:
1.
Pull out the pin locking the conveyor in place and lower the conveyor to the ground.
2.
Shut the machine down and disconnect it from its power sources.
3.
Move the belt joint to the start of the conveyor.
4.
Fold the conveyor, but do not place the belt support in the transport position. This will allow the
belt to hang loose.
5.
Disconnect the joint by opening the bolts.
6.
Remove the old belt.
7.
First, insert the new belt under the folded conveyor (bottom opening) from the end of the
conveyor with the plates facing downwards. Feed the belt in until you can pull it out from the
other end of the conveyor. Pull out a length of approx. 60 cm.
8.
Push the other end of the belt into the upper section of the folded conveyor (top opening) from
the end of the conveyor. Feed it in until you can connect the joint.
9.
Pull the excess belt to the start of the conveyor.
10.
Lower the conveyor back to the operating position and tension the belt.
The belt is at the correct tension when its middle section is raised approx. 15 cm when the conveyor is
in the operating position. An excessively tight belt may be damaged more easily, and it places
unnecessary strain on the conveyor bearings.
5.4.3.
Replacing the out-feed conveyor plates
The out-feed conveyor plates can be replaced by disconnecting the bolt joints (3 x M8) fastening the
plates and replacing the plates with new ones. It is recommended that you move the belt into a position
that puts the plate to be replaced above the conveyor. Shut the machine down and disconnect it from the
power source for the duration of the procedure.
5.5.
Lubrication
All of the firewood processor's lubrication points, which require Vaseline, have been labelled. There are
33 lubrication points, presented in the figures below. Note! Take care when applying grease to dustproof
bearings!
1.
Grease nipple of the out-feed conveyor’s turning joint (1 pc) in Figure 42. (every 50 hours)
2.
Grease nipples of the height adjustment device of the splitting blade (2 pcs) in Figure 43.
(every 50 hours)
3.
Bearing nipples of the out-feed conveyor’s lower roller (2 pcs) in Figure 44. (every 200 hours)
4.
Grease nipples of the guide plate (2 pcs, every 50 hours) and the grease nipple of the in-feed
conveyor drive roller in Figure 45. (every 200 hours)
5.
Grease nipples of the cutting cylinder (2 pcs) in Figure 46. (every 50 hours)
6.
Grease nipples of the splitting cylinder’s pin (2 pcs) in Figure 47. (every 50 hours)
7.
Grease nipples of the wood measuring device (2 pcs) and one of the guard’s two grease
nipples in Figure 48. (every 50 hours)
8.
Grease nipples of the out-feed conveyor’s swivel cylinder (2 pcs) in Figure 49. (every 50 hours)
9.
Grease nipples of the log press (7 pcs) in Figure 50. (every 50 hours)
10.
The guard’s second hinge nipple in Figure 51. (every 50 hours)
11.
Grease nipples of the measuring device (2 pcs) and the guide plate (2 pcs) in Figure 52. (every
50 hours)
