MANDO Adapt T812
Technical data
26
Order h49 7144.907-333
3.2 Performance values
NOTE
Material damage to the products use and/or to the
machine tool caused by exceeding the maximum
performance values!
Do not exceed the maximum performance values
[see »General information« chapter].
On all products used, do not exceed the lowest of
the maximum performance values.
Only use product in machine tools with the same
performance values.
INFORMATION
Details of maximum performance values can be found
on each product.
If, due to abrasive wear, those performance values
are no long legible, refer to the operating instructions.
The achievable actuation forces may vary as a result of the
maintenance status [lubrication status and level of contami-
nation] of the product [see »Maintenance schedule« chap-
ter].
The achievable clamping forces resulting from actuating
forces must be checked at regular intervals. For this, struc-
tural clamping force measurements must be performed.
3.3 Balancing quality
The product is balanced before leaving the factory [balanc-
ing quality - see »General information« chapter].
DANGER
Serious injuries caused by parts being ejected
centrifugally if products are not balanced cor-
rectly!
Do not clamp rotationally symmetrical work-
pieces, or do so only after contacting the manu-
facturer.
Never remove balancing screws and weights at-
tached to the product.
NOTE
Material damage caused by machining with incor-
rectly balanced products!
Do not clamp rotationally symmetrical work-
pieces, or do so only after contacting the manu-
facturer.
Never remove balancing screws and weights at-
tached to the product.