– 52 –
From an idle state (all LED's off) or from a standby state (LED's on but no cycle running), press and
hold the Start pad while rotating cycle selection knob 180 degrees, then release Start pad.
• Once
Service Mode is entered, all LED's will be flashing.
• The Cycle Selection knob is now used to control the test selection menu.
• Rotating the knob clockwise (CW) will increment the test numbers in the display.
• Rotating the knob counter-clockwise (CCW) will decrement the test number in the display.
• Once test number is selected, pressing Start will begin the selected test.
Exit Field Service Mode
• Field Service Mode will time out after 30 minutes if there is no user activity.
• Press and hold (3 seconds) Start pad.
• Press Power pad.
Consumer fault code mode provides a way for consumers to read the fault table from their dryers to
provide them to the call takers. This will allow the service technicians to bring the correct parts to the
service call.
•
From an idle state only (all LED's off), press and hold Start pad for 10 seconds.
• After holding the Start pad for 10 seconds, all LED's will turn on, signifying that the user may
release Start pad.
Behaviors While in Consumer Fault Code Mode
• The Pause and Door Lock LED's should be constantly blinking while in CFCM.
•
The first fault, if present, will show on the display.
• Pressing the Start pad will display the next fault code.
• Fault code will blink on the Seven Segment Display (SSD).
• At the end of the fault list, or if no faults present:
• Seven Segment Display (SSD) will blink “—”.
Exiting
Consumer Fault Code Mode
• Pressing any pad (other than Start) or turning any knob will exit Consumer Fault Code Mode.
• Consumer Fault Code Mode will time out after 10 minutes.
Consumer Fault Code Mode
Service Mode
Diagnostics and Service Information