REMOTE SYSTEM WIRING DIAGRAMS
This thermostat has been preprogrammed with energy saving settings
recommended under the EPA Energy Star program. When used with
remote systems, HAI recommends that the thermostat be configured
as "non-programmable" (See Setup Item 03 - "Display Options").
HAI AUTOMATION SYSTEMS
The thermostat can be connected to an HAI automation system. The
controller can send commands to the thermostat to change mode, cool
setting, heat setting, status of fan and hold, and other items.
Run a 3 (or 4) conductor wire from the HAI system to the thermostat
location. All thermostats on an Omni, OmniPro, or Aegis controller
are connected to Zone 16 and Output 8. Connect the red COMM
cable wire with the black COMM cable wire. Make the connections
(as shown in Figure 6) using the supplied wire splices.
Note: Do not connect the red COMM cable wire to 12V. If a 4
conductor wire is used, disconnect the red conductor. It is not used!
GRN
RED
BRN
GRY
COMM
BLACK
RED
BLACK
GREEN
YELLOW
CONTROLLER
3 OR 4 CONDUCTOR
WIRE. IF PRESENT,
RED WIRE NOT USED.
RC-100
18
