48
You can issue commands from a local (in-house) phone with Remote Commands Ok set to Yes or No. The default for Remote
Commands Ok is Yes.
Rings Before Answer
Your phone must ring this number of times before the OmniLT will answer an incoming call to your phone.
To change Rings Before Answer, enter the new number from 1 to 15, then press the ' # ' key.
The factory default for Rings Before Answer is 8.
Dial Type
The Dial Type specifies the type of dialing used when the OmniLT dials out. If you do not have Touch-Tone service, then Dial
Type must be set to Pulse.
The default dial type is Tone.
My Phone Number
My Phone Number is the phone number that will be announced when the OmniLT dials out in the event of an alarm. It should be
set to the phone number of the premises where your system is installed.
To enter phone numbers, press the keypad keys 0 - 9. You can put in a dash (-) for legibility by pressing the Off key. Press the ' #
' key after you have pressed all of the digits in the phone number.
For example, to enter the number 555-1234, press 555 'OFF' 1234 #.
Dial Out Number 1
Dial Out Number 1 is one of the 8 numbers that are stored in the system. In the event of an alarm, these numbers are dialed in the
order that is set up in the Dial Out Order for the particular type of alarm.
Dial out numbers 1 - 8 have On and Off times and days, so that no time is wasted calling you at the office at night or on a Sunday
if the alarm is activated.
For dial out number 1, you should enter your office number where you can be reached during working hours.
Enter the phone number the same way as described for My Phone Number.
You can cause the system to pause for two seconds between digits of the number by pressing the DAY key, which puts a T in the
number. Multiple Ts for longer pauses are allowed. You can also press the NIGHT key (*) and the AWAY key (#) for symbols
to get through some types of telephone or pocket beeper/pager systems.
If you wish to remove a phone number for a particular dial out number, press OFF then ' # ' (with the display showing a Dial Out
Number) to enter a single dash (-).
Phone numbers can be up to 24 digits.
DIAL OUT 1 ON
DIAL OUT 1 OFF
Dial out number 1 has two times associated with it, an On and Off time. The OmniLT will only call this number if the time and
days are between the Dial Out 1 On and Dial Out 1 Off times and dates.
Press # to change the On and Off times -
See
Set Up Codes
.
DIAL
OUT
1
ON:
12:00
AM
MTWTFSS
#=CHNG
↕
DIAL
OUT
1
OFF:
NEVER #=CHNG
↕
Summary of Contents for OMNI LT
Page 1: ...Owner s Manual Document Number 21R00 1 Rev 2 4 May 2003...
Page 68: ......
Page 69: ......
