HAI OMNI LT, Owner'S Manual

Page: 30 / 70

26
DEN LAMP
LAST COMMANDED OFF
↓
You may enter a unit number to start displaying the status of that unit, or simply press the down arrow key to scroll through the
list of units. The status display is as shown under Control, except that now the arrow keys may be used to continue scrolling
between units.
Porch Light 00:24:19
LAST COMMANDED ON
↓
You can also check the last commanded state and (if any) the remaining time duration of any Unit.
At this point, you may press the ' # ' key to control the unit as specified under Controlling Units.
2 = ZONE
The Zone Status menu allows you to view and scroll through the status of each zone input. To enter the Zone menu, from the
Status menu, press the 2 (ZONE) key on the console keypad. The system will display:
Front Door SECURE
ZONE 1
↓
You may enter a zone number to start displaying the status with zone, or simply press the down arrow key to start with the first
zone. The arrow keys may be used to continue scrolling between zones. For each zone, the display will show the zone name, the
zone number, and the current status of the zone:
3 = SUN (SUNRISE / SUNSET AUTOMATIC CALCULATION)
The system automatically calculates the time of sunrise and sunset each day. From the status menu, press the 3 (SUN) key on the
console keypad to display the calculated time of sunrise, sunset, and the outdoor temperature (if outdoor temp sensor installed):
Sunrise: 6:00 AM Temp
Sunset: 5:58 PM 85
4 = TEST (SYSTEM DIAGNOSTIC TEST)
The diagnostic test performed by the OmniLT allows you to check the status of the battery, telephone, bell circuit, auxiliary fuse,
and security zone loop readings. The display is updated 3 times per second, although the actual readings are taken 10 times per
second. To enter the Test menu, from the Status menu, press the 4 (TEST) key on the console keypad.
The first display shows the current battery reading and the phone line status. A battery test is initiated when the status mode is
first entered. The new battery reading is updated ten seconds later. The low battery limit is also displayed.
The phone status consists of two parts, separated by a "/". The first part shows the current phone line state:
ONHK
- ON HOOK OFFHK - OFF HOOK
RING - RINGING DEAD - DEAD PHONE LINE
The second part shows how the OmniLT is currently using the phone line:
IDLE - NOT USING THE PHONE LINE
LOCAL - LOCAL ACCESS
REMOTE - REMOTE ACCESS
VOICE - IN VOICE DIAL OUT MODE
EMGACC - ACCESS AFTER VOICE DIAL OUT
DCM - IN DIGITAL COMMUNICATOR MODE
BATTERY: 230 (LIMIT 200)
PHONE: ONHK/IDLE
↓