I-LS02111
www.hagerco.com
14
Rev 1, 5/16
The setting sequence will be exited if the idle time is more than 20 seconds, or
[#] is pressed to exit immediately.
LLL: User ID; Range 001-500; Type: General Access User
User Access Codes can be continuously activated with this function as shown above
in 3.1.13.4. Delete User Access Codes until finished by hitting [#].
3.1.13.9.
Activate Manager Access Codes
If a manager code has been deactivated for a period of time, such as during a
vacation, it can be reactivated using this function. Manager codes that will be
needed again in the future should be deactivated rather than deleted.
Use the following code to activate manager access codes that have been
deactivated:
[
＊
] [Master code] [
＊
] [31] [
＊
] [LLL] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If
the setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or
[#] is pressed to exit immediately.
LLL: User ID; Range 001-500; Type: Manager
Manager Access Codes can be continuously activated with this function as shown
above in 3.1.13.4. Delete User Access Codes until finished by hitting [#].
3.1.13.10.
Activate Service User Access Codes
If a service user code has been deactivated for a period of time, it can be
reactivated using this function.
Use the following code to activate service user access codes that have been
deactivated:
[
＊
] [Master or Manager code] [
＊
] [32] [
＊
] [LLL] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If
the setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or
[#] is pressed to exit immediately.
LLL: User ID; Range 001-500; Type: Service User
Service User Access Codes can be continuously activated with this function as shown
above in 3.1.13.4. Delete User Access Codes until finished by hitting [#].
