I-LS02111
www.hagerco.com
18
Rev 1, 5/16
2.
Connect the lock to the PC via the USB adaptor cable. The USB port on the lock is
located under the battery cover.
3.
Use the code below to activate the Connection Mode for the lock:
[
＊
] [Master code] [
＊
] [90] [
＊
] [01] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If the
setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or [#] is
pressed to exit immediately.
4.
After successfully activating the Connection Mode, the red light will turn on. You can
start using the PC software to communicate with the lock. For operation and parameter
settings, refer to the software instructions that are supplied with the software disc.
