Hafco Metalmaster HM-46B, Operation Manual

Page: 15 / 34

15
OPERATION MANUAL
4. OPERATION.
The purpose of this overview is to provide the novice machine operator with a basic under-
standing of how the machine is used during operation, so the machine controls/components
discussed later in this manual are easier to understand.
Due to the generic nature of this overview, it is not intended to be an instructional guide. To
learn more about specific operations, read this entire manual and seek additional training from
experienced machine operators, and do additional research outside of this manual by reading
“how-to” books, trade magazines, or visiting websites.
When undergoing a typical operation, the operator needs to do the following:
1. Examines the workpiece to make sure it is suitable for the machining operation.
2. Check the machine to ensure that it is safe to use and put on protective clothing and
safety equipment.
3. Place the workpiece on the table and securely clamp it to the table.
4. Select the correct cutting tool for the job and with the machine disconnected from power,
install the cutting tool using the correct holder.
5. Lower the headstock so the cutting tool is just above the workpiece.
6. Select the correct spindle speed for the cutter and the workpiece.
7. Connect the machine to the power supply and turn it ON.
8. Uses the down feed, or table controls to perform the cutting operation.
9. Turn the machine OFF and wait for the spindle to completely stop before removing the
workpiece, changing tooling, or changing spindle speeds.
4.1 OPERATION OVERVIEW
07/11/2019 Instructions Manual for HM-46B (M138D) 15